Hi everyone, I'm Louise from Do It Yourself Manchester. Today I wish to reveal you a quick Do It Yourself project that you can make as a gift: Do It Yourself wooden beverage coasters. I started by ordering some scrap items of timber. For this project I picked to utilize maple as well as walnut. I reduced them up into thinner strips so I could make an arbitrary pattern, rotating in between sorts of timber. My objective was to make a space that was at least 16 inches long by 3 and three quarter inches wide, with a density of concerning half an inch.
Once I had all my strips prepared, I laid some clamps open on their backs. I such as to utilize Bessey K-body clamps for this since they provide a flat steady surface. I turned all the pieces on side and used a generous amount of glue, spreading it over the whole surface with an adhesive brush. I after that flipped the pieces back up and clamped them completely. I always like to add scrap pieces on each end to remove the threat of leaving any kind of indentations on the work surface, particularly from these F-clamps that I'm including.
After the adhesive had dried out overnight, I got rid of the clamps as well as ran the blank via my planer, rotating sides, until both sides were also and also smooth, and also till I had reached my wanted density of about three eighths of an inch. I gently sanded the empty with my orbital sander prior to conforming to my table saw. I used a crosscut sled for this, but you can always make use of a mitre saw rather. I started by settling up one end of the board, then set a quit block to 3-3/4 inches, which coincides as the width of the board.
I then proceeded to reduce the 4 coasters. I lightly sanded all the edges just to make them much less sharp. Next I moved onto the base. I utilized a piece of poplar to match the poplar dowel I would be using. My poplar board was currently 4 inches vast, so I simply established a quit block to 4 inches and used my crosscut sled to make it. I did the exact same for the dowels, setting a stop block at 2-1/2 inches and also using it as a guide to make it. Do not forget to have a look at my written write-up for all the information as well as measurements. I'll leave a description in the web link below. I maked the base for where I would pierce the fix openings.
I utilized my mix square and also significant one half inch from each side. I double checked every little thing would certainly fit making use of one of the rollercoasters, simply to be risk-free. I after that headed over to my drill press as well as made the holes using a fifty percent inch spade. A Forstner bit would certainly have been better, but somehow I appear to every dimension however that. I did a completely dry fit after that sanded the base. I then included some glue to the openings as well as established the pegs right into area.
I put a lightweight on top as well as allow it completely dry over night. They look so outstanding already, I almost intend to leave them as is, but that would certainly be an awful idea offered these will certainly be in contact with moisture. You can go straight to wood coasters for sale poly, however I wanted to give the grain an extra abundant color, so I started by using some natural-color Danish oil. I let it completely dry for 3 days as recommended, then added a leading layer of oil-based poly.